Assembly Procedure

WARNING: This page is about a different car, the 2011 Chevrolet Volt. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Compressing Front Spring

Courtesy of GENERAL MOTORS CORP.

Install the front spring and front suspension strut mount (2) to the CH 6066: compressor (1).
Using the CH 6066: compressor (1), compress the front spring (2).
Hand tighten the front suspension strut nut.

Fig 2: View Of TORX(R) Bit And Special Wrench

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to Fastener Caution .

NOTE: Use the proper size TORX® bit, hold the strut shaft.

Using the CH 35669: wrench (2) and the TORX® bit (1), tighten the front suspension strut nut to 70 N.m (52 lb ft).
Remove the front suspension strut from the CH 6066: compressor.
Install the front suspension strut to the vehicle. Refer to Strut Assembly Removal and Installation .