LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2014 >> Impala LS >> Repair and Diagnosis >> Brakes >> Traction Control >> Antilock Brake System >> Repair Instructions >> Electronic Brake and Traction Control Module with Brake Pressure Modulator Valve Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

  1. Install the EBTCM assembly to the bracket.
    2. Fig 1: BPMV Assembly Bracket Bolts
    GM2739969Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  2. Install the EBTCM assembly bracket bolt (1) and tighten to 10 (89 lb in).
  3. Install the EBTCM assembly.
    4. Fig 2: BPMV Assembly Bracket Nuts
    GM2739902Courtesy of GENERAL MOTORS COMPANY
  4. Install the EBTCM assembly bracket nuts (1) and tighten to 22 (16 lb ft).
    5. Fig 3: Right Front & Left Rear Brake Pipe Fittings
    GM2739899Courtesy of GENERAL MOTORS COMPANY
  5. Install the right front brake pipe fitting (1) and tighten to 18 (13 lb ft).
  6. Install the left rear brake pipe fitting (2) and tighten to 18 (13 lb ft).
    7. Fig 4: Right Rear & Left Front Brake Pipe Fittings
    GM2739896Courtesy of GENERAL MOTORS COMPANY
  7. Install the right rear brake pipe fitting (1) and tighten to 18 (13 lb ft).
  8. Install the left front brake pipe fitting (2) and tighten to 18 (13 lb ft).
    9. Fig 5: Master Cylinder Brake Pipe Fittings
    GM2739893Courtesy of GENERAL MOTORS COMPANY
  9. Install the master cylinder secondary brake pipe fitting (1) and tighten to 25 (18 lb ft).
  10. Install the master cylinder primary brake pipe fitting (2) and tighten to 25 (18 lb ft).
  11. Connect the EBCM electrical connector.
  12. Connect the brake fluid level sensor electrical connector.
  13. Install the radiator surge tank. Refer to Radiator Surge Tank Replacement (LFX) , Radiator Surge Tank Replacement (LKW) , Radiator Surge Tank Replacement (LUK) .
  14. Install the battery tray. Refer to Battery Tray Replacement .
  15. Program the EBCM. Refer to Control Module References .
  16. Bleed the antilock brake system. Refer to Antilock Brake System Automated Bleed .
  17. Perform the Diagnostic System Check - Vehicle .
  18. Calibrate the brake pedal position sensor. Refer to Brake Pedal Position Sensor Calibration .
  19. Center the steering angle sensor. Refer to Steering Angle Sensor Centering .
scientia non olet · About LEMON Manuals