LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2014 >> Impala LS >> Repair and Diagnosis >> Brakes >> Traction Control >> Antilock Brake System >> Repair Instructions >> Front Wheel Speed Sensor Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: Wheel Speed Sensor And Harness Clip
    GM2278446Courtesy of GENERAL MOTORS COMPANY
  1. Install the wheel speed sensor (1) to the steering knuckle.
  2. Install the harness clip (2) to the steering knuckle.
    3. Fig 2: Wheel Speed Sensor Bolt
    GM2278445Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  3. Install the wheel speed sensor bolt (1) and tighten to 9 N.m (80 lb in).
    4. Fig 3: Wheel Speed Sensor Electrical Connector & Harness Clips
    GM2278444Courtesy of GENERAL MOTORS COMPANY
  4. Connect the wheel speed sensor electrical connector (1) and secure the connector to the frame.
  5. Install the harness clip (2) to the frame.
  6. Install the harness clips (3) to the lower control arm.
  7. Install the front compartment splash shield. Refer to Front Compartment Splash Shield Replacement .
  8. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  9. Perform the Diagnostic System Check - Vehicle .
scientia non olet · About LEMON Manuals