Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Fig 1: Battery Energy Control Module Junction Block Fasteners

Courtesy of GENERAL MOTORS COMPANY

CAUTION:

Install the drive motor battery wire junction block relay (2) and tighten the fasteners (1) to 9 N.m (80 lb in).

Fig 2: Cut-Off Switch Fastener

Courtesy of GENERAL MOTORS COMPANY

Connect the following to the generator battery disconnect relay junction block :
- Current Sensor Connector (3).
- Pre-Charge Contacts (4).
- Contactor Connector (5).

Fig 3: Generator Control Module Connector

Courtesy of GENERAL MOTORS COMPANY

Fig 4: High Voltage Battery Cables-To-Batteries Fasteners

Courtesy of GENERAL MOTORS COMPANY

Install the fasteners (2) retaining the junction block to the generator control module.
Position the high voltage cables through the cable retaining clip (1).

NOTE:

Critical high voltage fastener. Perform second torque verification check following re-assembly.

Install the high voltage cables to the batteries and tighten the fasteners (3) to 9 N.m (80 lb in).
Enable the hybrid battery. Refer to High Voltage Enabling .