LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2014 >> Orlando LS, Automatic Trans >> Repair and Diagnosis >> Brakes >> Traction Control >> Antilock Brake System >> Repair Instructions >> Brake Pressure Modulator Valve Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

WARNING:

Refer to Brake Fluid Irritant Warning .

CAUTION:

Refer to Brake Fluid Effects on Paint and Electrical Components Caution .

  1. Prepare electronic brake control module (EBCM/EBTCM) for replacement. Refer to Control Module References .
  2. Turn the ignition to OFF position.
  3. Remove the battery tray. Refer to Battery Tray Replacement .
    4. Fig 1: View Of Radiator Surge Tank And Radiator Surge Tank Clip
    GM2027873Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Do NOT disconnect engine coolant hoses.

  4. Remove the radiator surge tank clip (2).
  5. Remove the radiator surge tank (1).

    Position the radiator surge tank (1) aside.

    6. CAUTION:

    Always connect or disconnect the wiring harness connector from the EBCM/EBTCM with the ignition switch in the OFF position. Failure to observe this precaution could result in damage to the EBCM/EBTCM.

  6. Disconnect the electrical connector from the EBCM/EBTCM.
    7. Fig 2: Brake Pipe Fittings At BPMV
    GM2027877Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Cap the brake pipe fittings to prevent brake fluid loss and contamination.

  7. Remove the 6 brake pipes (1, 2) from the brake pressure modulator valve (BPMV).
    8. Fig 3: BPMV and BPMV Bracket Bolts
    GM2027887Courtesy of GENERAL MOTORS COMPANY
  8. Remove the 2 BPMV bracket bolts (2).
  9. Remove the BPMV bracket assembly (1).
    10. Fig 4: BPMV and BPMV Bracket Bolts
    GM2027916Courtesy of GENERAL MOTORS COMPANY
  10. Remove the 3 BPMV bracket bolts.
  11. Remove the BPMV (2).
  12. Remove the BPMV insulator (1) from the BPMV bracket (3).
scientia non olet · About LEMON Manuals