Common Specs & Procedures Index

ORLANDO COMMON SPECS & PROCEDURES

System		Specification/Procedure
Air Conditioning
Service
Torque		Automatic - Manual -
Axle Nut/Hub Nut
First Pass - 150 N.m (111 lb ft) Release - 45° Final Pass - 250 N.m (184 lb ft)
Battery		N/A
Brakes
Bleeding Sequence		RIGHT REAR, LEFT REAR, RIGHT FRONT, LEFT FRONT
Disc Brakes
	Service Specifications
	Torque
Charging
Generator
Torque
Drive Belts
Adjustment		Non-Adjustable Serpentine Belt
Drive Belt Routing		See Figure Under
Engine Cooling
General Service Specifications		N/A
	Radiator Cap Pressure	Pressure Stamped On Radiator Cap Or Surge Tank Cap
	Thermostat R & I
	2.4L
	Water Pump R & I
	2.4L
Engine Mechanical
2.4L
	Compression	No cylinder should be less than 70 percent of highest cylinder. No cylinder should read less than 690 kPa (100 psi)
	Oil Pressure	Minimum @ 1,000 RPM @ 90°c (194°F) - 206.84-482.63 kPa (30-70 psi)
	Overhaul
	Torque
Fluid Specifications		See FLUIDS under MAINTENANCE/FLUIDS tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button.
Flywheel/Flex Plate/Drive Plate Torque		First Pass - 53 N.m (39 lb ft) Final Pass 25°
Fuel System
Pressure Specification		Ignition ON, Engine OFF, 345-690 kPa (50-100 psi) Engine at IDLE, 300-400 kPa (43-58 psi)
	Fuel Pressure Test Procedure
	Fuel Filter Location	Fuel Filter Is Part of the Fuel Tank Fuel Pump Module
	Fuel Filter R & I
Ignition
Firing Order & Cylinder Identification
Ignition Wires (Resistance)		Individual Ignition Coil/Module Assemblies
Ignition Wires (Routing)
2.4L		Coil On Plug
Spark Plug - See Parts catalog for spark plug usage.
2.4L
	Gap	0.75-0.90 mm (0.030-0.035 lb ft)
	Torque	20 N.m (15 lb ft)
Starting
Starter		N/A
Torque
Wheel Alignment
	Adjustment Specifications
	Torque
Wheel & Tire
Wheel Lug Nut Torque		140 N.m (103 lb ft) For wheel nut tightening sequence (star pattern), see illustration under