Multi-Axis Acceleration Sensor Module Configuration
WARNING: This page is about a different car, the 2013 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The Multi-axis Acceleration Sensor is also known as the Inertia Sensor Module (IMU) in SPS. The sensor must be configured using SPS before the vehicle Yaw Sensor Learn is performed.
A replacement Multi-axis Acceleration Sensor Module, requires the following procedure:
- Install EL-49642 SPS Programming Support Tool..
- Access the Service Programming System (SPS) and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select IMU Inertia Sensor Module - Configuration and follow the on-screen instructions.
- At the end of programming, choose the "Clear All DTCs" function on the SPS screen.
- With a scan tool, perform the Yaw Sensor Learn. Refer to Vehicle Yaw Sensor Learn .