LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2014 >> Traverse LS, 4D Utility >> Repair and Diagnosis >> Engine Mechanical >> Fuel System >> Engine Controls And Fuel - 3.6L (LLT) - Repair Instructions >> Repair Instructions >> Accelerator Pedal Position Sensor Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

  1. Install the upper bolt into the APP sensor assembly.
    Fig 1: View Of APP Sensor Bolts & Sensor
    GM1858232Courtesy of GENERAL MOTORS COMPANY
  2. Install the APP sensor assembly into the vehicle.
  3. Install the remaining 2 lower APP sensor assembly bolts.
    CAUTION: Refer to Fastener Caution .

    Tighten 

    Tighten the bolts to 8 N.m (71 lb in).

  4. Install the I/P wiring harness electrical connector (2) to the APP sensor assembly.
    Fig 2: Identifying Accelerator Pedal Position Sensor Assembly
    GM1858231Courtesy of GENERAL MOTORS COMPANY
  5. Install the driver knee bolster. Refer to Driver Knee Bolster Replacement (Acadia) , Driver Knee Bolster Replacement (Enclave) , Driver Knee Bolster Replacement (Traverse) .
  6. Install the left I/P insulator. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
scientia non olet · About LEMON Manuals