LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2014 >> Trax LS, Automatic Trans >> Repair and Diagnosis >> Brakes >> Traction Control >> Antilock Brake System >> Repair Instructions >> Rear Wheel Speed Sensor Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: Wheel Speed Sensor
    GM2768795Courtesy of GENERAL MOTORS COMPANY
  1. Install the wheel speed sensor (1) to the rear suspension knuckle.
    2. Fig 2: Wheel Speed Sensor Bolt
    GM2768794Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  2. Install the wheel speed sensor bolt (1) and tighten to 8 N.m (71 lb in).
    3. Fig 3: Wheel Speed Sensor Harness Clips
    GM2768792Courtesy of GENERAL MOTORS COMPANY
  3. Install the wheel speed sensor harness clips (1) to the rear axle.
    4. Fig 4: Wheel Speed Sensor Electrical Connector
    GM2768790Courtesy of GENERAL MOTORS COMPANY
  4. Connect the wheel speed sensor electrical connector (1) and install the connector clip to the wheelhouse bracket.
  5. Install the wheel speed sensor harness clip (2) to the wheelhouse panel.
  6. Install the rear wheelhouse panel liner. Refer to Rear Wheelhouse Liner Replacement .
  7. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  8. Perform the diagnostic system check. Refer to Diagnostic System Check - Vehicle .
scientia non olet · About LEMON Manuals