Assembly Procedure

Install the front spring (2) and front suspension strut mount in the CH 6066 compressor (1).

Fig 1: View Of Compressor Forcing Screw & Coil Spring
Courtesy of GENERAL MOTORS COMPANY
Using the CH 6066 compressor (1), compress the front spring (2).
Hand tighten the front suspension strut nut.
Using the CH 35669 wrench (2) and the TORX® bit (1), tighten the front suspension strut nut to 70 N.m (52 lb ft).

Fig 2: View Of TORX Bit And Special Wrench
Courtesy of GENERAL MOTORS COMPANY

CAUTION: Refer to Fastener Caution .

NOTE: Use the proper size TORX® bit to hold the strut shaft.
Remove the front suspension strut from the CH 6066 compressor (1).
Install the front suspension strut on the vehicle. Refer to Strut Assembly Removal and Installation .