Installation Procedure

Remove the CH-6015 plugs from fuel feed tank pipe and fuel feed pipe.
Install the fuel feed pipe and secure with the rear fuel pipe clip.

Fig 1: Fuel Tank Feed Pipe Connector
Courtesy of GENERAL MOTORS COMPANY
Connect the fuel tank feed pipe connector (1) to the fuel feed pipe. Refer to Plastic Collar Quick Connect Fitting Service .
Close the 5 fuel pipe clips (1).

Fig 2: Fuel Pipe Clips
Courtesy of GENERAL MOTORS COMPANY
Install the EVAP canister cover (2) and tighten the EVAP canister cover fasteners (1) to 9 N.m (71 lb in).

Fig 3: EVAP Canister Cover & Fasteners
Courtesy of GENERAL MOTORS COMPANY
Install the frame reinforcement (2) and tighten the frame reinforcement fasteners (1) to 60 N.m (44 lb ft).

Fig 4: Frame Reinforcement & Fasteners
Courtesy of GENERAL MOTORS COMPANY
Lower the vehicle.
Connect the electrical wiring harness connector to the fuel pressure sensor (4).

Fig 5: Fuel Feed System Components
Courtesy of GENERAL MOTORS COMPANY
Clip the fuel feed pipe (2) into the retainer clip (3).
Remove the CH-807 plugs from the fuel feed pipe connectors.
Connect the front fuel feed pipe connector (1) to the fuel injector rail and the fuel feed pipe (2). Refer to Plastic Collar Quick Connect Fitting Service .
Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .