LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2015 >> Spark LS, Automatic CVT Trans >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 1.2L - Diagnostic Information And Procedures >> Diagnostic Information and Procedures >> Inspection/Maintenance Complete System Set Procedure >> Inspection/Maintenance System Set Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Inspection/Maintenance System Set Procedure

NOTE: Whenever the ignition is turned ON, ignition positive voltage is supplied to the heated oxygen sensor (HO2S) heaters. After verifying the enable criteria, turn OFF the ignition for approximately 5 minutes to allow the sensors to cool before continuing with the test. Once the engine is started, do NOT turn the engine OFF for the remaining portion of the set procedure.
  1. Ensure that the vehicle meets the conditions for a cold start listed above.
    • If the Evaporative Emission (EVAP) inspection/maintenance system status indicator displays NO, perform the EVAP Service Bay test if applicable.
  2. Turn OFF all accessories; HVAC system, other electrical loads, including aftermarket/add-on equipment, etc. and open the hood.
  3. Set the vehicle parking brake and ensure the vehicle is in park for automatic transmission or neutral for manual transmission.
  4. Turn the ignition ON for 1 min.
  5. Start and idle the engine for 5 min.
  6. Run the engine for 6 min within the following conditions:
    • Calculated air flow is between 9-30 g/s
    • Engine speed is steady between 1300-3000 RPM
  7. Apply and hold brake pedal and shift to Drive for automatic or apply clutch pedal for manual and operate the vehicle within the following conditions for 2 min:
    • Manifold Absolute Pressure (MAP) signal is greater than 12 g/s
    • Engine speed is greater than 1000 RPM
  8. Release the accelerator pedal and shift the vehicle to Park for automatic or Neutral and release clutch pedal for manual and allow the engine to idle for 2 min.
    NOTE: Do NOT touch the accelerator pedal until told to do so. A change in throttle position sensor angle or an increase in engine speed may invalidate this portion of the test.
  9. Close the hood, release the parking brake and drive vehicle at 90 km/h (55 MPH) for 2 min.
  10. Release the accelerator pedal for at least 10 s. This will allow the vehicle to enter the deceleration fuel cut off.
  11. Safely stop the vehicle, with the engine in drive for automatic or neutral with the clutch pedal depressed and parking brake applied for manual. Allow the vehicle to idle for 2 min.
  12. Shift the vehicle to park for automatic and neutral for manual. Turn OFF the ignition and exit the vehicle. Do NOT disturb the vehicle for 45 min.
    NOTE: Do NOT disturb the vehicle or turn ON the ignition until told to do so. Disturbing the vehicle may invalidate this portion of the test.
  13. Observe the Inspection/Maintenance System Status with a scan tool. All of the inspection/maintenance System Status indicators should display YES.
    • If the EVAP inspection/maintenance system status indicator displays NO, turn OFF the ignition, ensure that the vehicle meets the conditions for a cold start and repeat steps  6 through  11 three more times or until the EVAP inspection/maintenance system status indicator transitions to yes. If the indicator continues to display NO, refer to the Inspection/Maintenance (I/M) System DTC Table  to identify the DTCs that did not run.
    • If any of the inspection/maintenance system status indicators display NO, refer to the Inspection/Maintenance (I/M) System DTC Table  for the indicator which did not display yes. The inspection/maintenance system DTC table identifies the DTCs associated with each inspection/maintenance system status Indicator.
scientia non olet · About LEMON Manuals