LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2016 >> Cruze L >> Repair and Diagnosis >> Body & Frame >> Ignition Switch/Steering Lock >> Immobilizer System >> Repair Instructions >> Programming Additional Keys (without BTM) >> Adding Keys (With SPS)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Adding Keys (With SPS)

NOTE:
  • This procedure may be used with or without existing learned keys being present.
  • A total of eight keys and transmitters maybe be learned to a single vehicle. Each key and each transmitter is one key.
  • This procedure will only learn the vehicle key information. This procedure will not learn any immobilizer information between the body control module (BCM) and engine control module (ECM).
  • If the battery voltage is low, charge the battery before continuing with the procedure.
  1. Connect a scan tool to the vehicle and access SPS.
  2. Ensure that all power consuming devices are turned OFF on the vehicle.
  3. Select the SPS application and follow the on-screen instructions.
  4. Select Reprogram ECU.
  5. Select IMMO Immobilizer Learn - Setup.
  6. Select the Program Transponder or Remote Key (Add) function.
  7. Follow the on-screen instructions.
  8. After programming all keys, "Programming Complete" is displayed.
  9. With a scan tool, clear any DTCs.
  10. Verify each key is operating properly by starting the vehicle. When verifying operation, make sure that no other keys are near the vehicle.
scientia non olet · About LEMON Manuals