LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2016 >> Cruze L >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Battery Negative Cable Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

  1. Without start/stop system use the following steps:
    1. Battery Current Sensor (2)» Install
      Fig 1: Battery Negative Cable Terminal Cover And Battery Current Sensor
      GM4091391Courtesy of GENERAL MOTORS COMPANY
    2. Install the battery negative cable terminal cover (1).
    3. Battery Negative Cable Clip (1)» Install [2x]
      Fig 2: Battery Current Sensor Connector
      GM4091389Courtesy of GENERAL MOTORS COMPANY
    4. Battery Current Sensor Connector (2)» Connect
    5. Install body extension current sensor wiring harness to battery negative cable bolt (1) and tighten to 9 N.m (80 lb in).
      Fig 3: Body Extension Current Sensor Wiring Harness To Battery Negative Cable Bolt
      GM4091410Courtesy of GENERAL MOTORS COMPANY
      CAUTION: Refer to Fastener Caution .
    6. Connect the battery negative pole clamp (1).
      Fig 4: Battery Negative Pole Clamp And Nut
      GM4091388Courtesy of GENERAL MOTORS COMPANY
    7. Tighten the battery negative pole clamp nut (2) to 4 N.m (35 lb in).
  2. With start/stop system use the following steps:
    1. Battery Negative Cable Clip (1)» Install [2x]
      Fig 5: Battery Negative Cable Clips
      GM4091413Courtesy of GENERAL MOTORS COMPANY
    2. Battery Negative Cable (3)» Install
      Fig 6: Battery Negative Cable Nut
      GM4091412Courtesy of GENERAL MOTORS COMPANY
      NOTE: Use a counterholder to prevent the battery sensor from damage.
    3. Install a open-end spanner (1) to counter-hold the battery sensor as shown in the graphic.
    4. Install the battery negative cable nut (2) and tighten to 11 N.m (97 lb in).
    5. Tighten the battery negative pole clamp nut to 4 N.m (35 lb in).
  3. Battery Negative Cable Disconnection and Connection » Connect
  4. Fold the rear seat back cushion in original position.
  5. Close the right rear door.
  6. Rear Compartment Floor Panel Trim Support Replacement » Install
  7. Rear Compartment Floor Panel Trim Replacement » Install
  8. Close the rear compartment lid.
  9. Ignition» On / Vehicle» In Service Mode & Engine» Off
  10. Program the volatile memory. Refer to Volatile Memory Programming
  11. Program all of the customer's radio station presets and set the radio clock to the current time.
scientia non olet · About LEMON Manuals