LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2016 >> Cruze L >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Battery Positive Cable Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

  1. If the battery positive cable will not be replaced, check the grommet (1) for damage. If the grommet is damaged, replace the grommet, see next steps.
    Fig 1: Grommet, Retainer And Clip
    GM4091512Courtesy of GENERAL MOTORS COMPANY
    1. Release the retainer (2) and open the clip (3). Then remove.
    2. Liberally lubricate the grommet and the cable to slide grommet over the over the positive cable terminal.
    3. Liberally lubricate the NEW grommet and the cable to slide grommet over the over the positive cable terminal.
    4. Install the clip to the positive cable and lock the retainer.
    5. Remove the silicon spray or soap water from the positive cable.
  2. Pull the complete battery positive cable through the body until the grommet locks into the original position.
    Fig 2: Battery Positive Cable
    GM4087971Courtesy of GENERAL MOTORS COMPANY
  3. Install 3 wire tie retainers (1, 2) on the rear left body in front of the rear axle.
    Fig 3: Wire Tie Retainers
    GM4087970Courtesy of GENERAL MOTORS COMPANY
  4. Battery Positive Cable» Install
    Fig 4: Battery Positive Cable Retainer Nuts
    GM4087972Courtesy of GENERAL MOTORS COMPANY
  5. Install the 6 battery positive cable retainer nuts (1) and tighten to 9 N.m (80 lb in).
    CAUTION: Fastener Caution
  6. Retainer (1)» Install [3x]
    Fig 5: Retainers
    GM4087967Courtesy of GENERAL MOTORS COMPANY
  7. Install a new zip tie to the plastic nut and secure the battery positive battery cable.
    Fig 6: Bat Positive Cable Wire Tie From Plastic Nut
    GM4087966Courtesy of GENERAL MOTORS COMPANY
    NOTE: For a better access, install the wire tie through the wheelhouse.
  8. Lower the vehicle.
  9. Check the distance (a) 255 mm (10 in) of the battery positive cable.
    Fig 7: Distance Of Battery Positive Cable
    GM4091419Courtesy of GENERAL MOTORS COMPANY
  10. Check the 6 retainers (1) of the battery positive cable (2) for proper seat.
    Fig 8: Battery Positive Cable Bolt
    GM4087969Courtesy of GENERAL MOTORS COMPANY
  11. Install the battery positive cable bolt (3) and tighten to 15 N.m (11 lb ft).
  12. Install the cover (3).
    Fig 9: Retainers And Covers
    GM4087968Courtesy of GENERAL MOTORS COMPANY
  13. Lock the 3 retainers (4, 5).
  14. Install the cover (2).
  15. Lock the 10 retainers (1).
  16. Rear Compartment Floor Panel Trim» Install
  17. Install the battery positive cable bolt (1) and tighten to 15 N.m (11 lb ft).
    Fig 10: Battery Positive Distribution Cover And Cable Bolt
    GM4087965Courtesy of GENERAL MOTORS COMPANY
  18. Install the battery positive distribution cover (1).
    Fig 11: Battery Positive Distribution Cover
    GM4091417Courtesy of GENERAL MOTORS COMPANY
  19. Lock the 2 retainers (2).
  20. Battery Negative Cable Disconnection and Connection » Connect
scientia non olet · About LEMON Manuals