Installation Procedure

Battery Current Sensor (2)» Install

Fig 1: Battery Negative Cable Terminal Cover And Battery Current Sensor
Courtesy of GENERAL MOTORS COMPANY
Install the battery negative cable terminal cover (1).
Battery Negative Cable Clip (1)» Install [2x]

Fig 2: Battery Current Sensor Connector
Courtesy of GENERAL MOTORS COMPANY
Battery Current Sensor Connector (2)» Connect
Install body extension current sensor wiring harness to battery negative cable bolt (1) and tighten to 9 N.m (80 lb in).

Fig 3: Body Extension Current Sensor Wiring Harness To Battery Negative Cable Bolt
Courtesy of GENERAL MOTORS COMPANY

CAUTION: Refer to Fastener Caution .
Connect the battery negative pole clamp (1).

Fig 4: Battery Negative Pole Clamp And Nut
Courtesy of GENERAL MOTORS COMPANY
Tighten the battery negative pole clamp nut (2) to 4 N.m (35 lb in).
Battery Negative Cable Disconnection and Connection » Connect
Fold the rear seat back cushion in original position.
Close the right rear door.
Rear Compartment Floor Panel Trim Support Replacement » Remove
Rear Compartment Floor Panel Trim Replacement » Remove
Close the rear compartment lid.
Ignition» On / Vehicle» In Service Mode & Engine» Off
Program the volatile memory. Refer to Volatile Memory Programming
Program all of the customer's radio station presets and set the radio clock to the current time.