without Navigation System
WARNING: This page is about a different car, the 2015 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the GPS and cellular coax cable connector at the K73 Telematics Communication Interface Control Module.NOTE: You must perform the Circuit/System Verification before proceeding with Circuit/System Testing.
- Attach the EL-49903-1 OnStar® test antenna to the EL-49903-5 combiner. Using the EL-49903-6 brown -F coax cable attach the combiner to the K73 Telematics Communication Interface Control Module. Place the test antenna on the roof of the vehicle, ignition ON.
- Verify DTC B2462 is not set or that the OnStar® advisor can locate the vehicle.
- If DTC B2462 is set or the advisor can not locate the vehicle
Replace the K73 Telematics Communication Interface Control Module.
- If DTC B2462 is not set or the advisor can locate the vehicle
- If DTC B2462 is set or the advisor can not locate the vehicle
- Test the coax cable between the K73 Telematics Communication Interface Control Module and the T4G Cellular Phone, Navigation and Digital Radio Antenna. Refer to Component Testing .
- If the coax cable does not pass the test
Replace the coax cable.
- If the coax cable passes the test
- If the coax cable does not pass the test
- Test or replace the T4G Cellular Phone, Navigation and Digital Radio Antenna.