ATEQ TPMS Reset Procedure

NOTE: Unless otherwise stated, on most tire pressure sensor equipped vehicles, low tire pressure indicator lights and messages can be cleared by inflating tires to the specified pressure and driving at least 25 mph or more for a few minutes. A sensor activation tool (TPMS3) can be used in place of driving.

Set the tire pressure of all wheels to pressure specified on the tire and loading information label.
Set the parking brake.
Put the vehicle in ON/ RUN and place the vehicle in P (Park).
If the Driver Information Center (DIC) display is minimized, press the SELECT knob to maximize it.
Use the SELECT knob to scroll to the Tire Pressure display screen.
Press and hold the SELECT knob for five seconds to begin the sensor matching process. A message displays confirming to begin the process.
Use the SELECT knob to select YES with the highlighted selection, and press the SELECT knob again to confirm the selection.
The horn sounds twice to signal the receiver is in relearn mode and the TIRE LEARNING ACTIVE message displays on the DIC screen.
Starting with left front tire, hold the TPMS3 against the side wall of the tire, within 3 inches of the valve stem. Press TEST button on the TPMS3 until a horn chirp sounds.
After horn chirp has sounded and the right turn signal has illuminated, proceed to the next 3 sensors in the following order: right front, right rear and left rear.
After left rear sensor has been learned, a double horn chirp will sound, indicating all 4 sensor IDs have been learned. Turn ignition switch to OFF position to exit Learn Mode.