LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2016 >> Trax LT, AWD >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Generator Replacement (LE2) >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: Generator
    GM4169707Courtesy of GENERAL MOTORS COMPANY
  1. Generator (4) - Install
    2. CAUTION:

    Refer to Fastener Caution

  2. Generator Mounting Stud (3)Install and tighten 9 N.m (80 lb in)
  3. Generator Mounting Nut (2) Install and tighten 22 N.m (16 lb ft)
  4. Generator Bolt (1)Install and tighten 22 N.m (16 lb ft)
    5. Fig 2: Battery Positive Cable
    GM4169704Courtesy of GENERAL MOTORS COMPANY
  5. Electrical Connector (4) - Connect
  6. Battery Positive Cable (2) - Install
  7. Battery Positive Cable Nut (2) - Install and tighten 17 N.m (13 lb ft)
  8. Generator Terminal Protective Boot (1) - Install
  9. Drive Belt - Install Drive Belt Replacement
  10. Front Wheel Drive Shaft-Right Side - Front Wheel Drive Shaft Replacement - Right Side
  11. Front Compartment Front Center Insulator - Install Front Compartment Front Center Insulator Replacement
  12. Lower the vehicle.
  13. Connect the negative battery cable. Battery Negative Cable Disconnection and Connection (without KL9) Battery Negative Cable Disconnection and Connection (with KL9) 
scientia non olet · About LEMON Manuals