LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2016 >> Volt Premier >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Battery Positive Cable Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

  1. Position the battery positive cable to the vehicle.
  2. Insert the battery positive cable to the body harness.
  3. Push the battery positive cable terminal through the grommet into the front engine compartment.
    4. Fig 1: Battery Positive Cable And Retaining Tabs
    GM4091098Courtesy of GENERAL MOTORS COMPANY
  4. Close the cover (1).
  5. Install Engine Wiring Harness Junction Block Engine Wiring Harness Junction Block Replacement 
  6. Install Windshield Wiper System Module Windshield Wiper System Module Replacement
  7. Install Dash Upper Extension Panel Opening Cover Dash Upper Extension Panel Opening Cover Replacement
    8. Fig 2: Retainer
    GM4091097Courtesy of GENERAL MOTORS COMPANY
  8. For a better access, fold the floor carpet aside.
  9. Install Retainer (1)
    10. Fig 3: Battery Positive Cable And Floor Carpet
    GM4091096Courtesy of GENERAL MOTORS COMPANY
  10. For a better access, fold the floor carpet (2) aside.
  11. Install the battery positive cable (1) to the left channel.
    12. Fig 4: Retainer
    GM4091095Courtesy of GENERAL MOTORS COMPANY
  12. Install Retainer(1)
  13. Install Center Pillar Lower Trim Panel Center Pillar Lower Trim Panel Replacement
    14. Fig 5: Retainer
    GM4091094Courtesy of GENERAL MOTORS COMPANY
  14. Install Retainer (1)
  15. Install Quarter Lower Rear Trim Panel Quarter Lower Rear Trim Panel Replacement (Left Side)Quarter Lower Rear Trim Panel Replacement (Right Side)
    16. Fig 6: Battery Positive Cable Fuse Block Nut
    GM4091093Courtesy of GENERAL MOTORS COMPANY
  16. Install Retainer (1)
    17. CAUTION:

    Fastener Caution

  17. Install the battery positive cable fuse block nut (2) and tighten to 9 N.m (80 lb in).
    18. Fig 7: Battery Fuse Block Cover And Retaining Tabs
    GM4091072Courtesy of GENERAL MOTORS COMPANY
  18. Install Battery Fuse Block Cover (2)
  19. Lock the 2 retaining tabs (1).
    20. Fig 8: Panel Trim And Nuts
    GM4091071Courtesy of GENERAL MOTORS COMPANY
  20. Install the panel trim (2).
  21. Install the 3 panel trim nuts (1) and tighten to 6 N.m (53 lb in).
  22. Connect Battery Negative Cable Battery Negative Cable Disconnection and Connection 
  23. Install Rear Compartment Floor Stowage Trim Compartment Rear Compartment Floor Stowage Trim Compartment Replacement
scientia non olet · About LEMON Manuals