LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2016 >> Volt Premier >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 1.5L (L3A) - Repair Instructions >> Repair Instructions >> Fuel Pressure Sensor Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: Fuel Pressure Sensor, Seal Ring And Electrical Connector
    GM4091047Courtesy of GENERAL MOTORS COMPANY
  1. Install a NEW seal (3).
    2. CAUTION:

    Refer to Component Fastener Tightening Caution

  2. Install and tighten Fuel Pressure Sensor (2) to 15 N.m (11 lb ft)
  3. Connect the electrical connector (1).
  4. Remove the drain pan.
  5. Install Underbody Front Air Deflector - Left Side. Refer to Underbody Front Air Deflector Replacement - Left Side
  6. Cycle the ignition to run the fuel pump and check for fuel leaks.
scientia non olet · About LEMON Manuals