LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2017 >> Camaro SS, 2D Convertible, Automatic Trans >> Repair and Diagnosis >> Accessories & Equipment >> Anti-Theft Systems >> Keyless Entry System And Remote Functions >> Repair Instructions >> Remote Control Door Lock and Theft Deterrent Transmitter Programming >> Replacing Transmitters (Without SPS)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Replacing Transmitters (Without SPS)

NOTE:
  • This procedure will unlearn all previously learned transmitters. All transmitters that are to be programmed must be with the vehicle at the time of service.
  • This procedure will take approximately 30 minutes to complete.
  • A total of 8 transmitters can be learned to a single vehicle.
  • This procedure will only learn the vehicle transmitter information. This procedure will not learn any immobilizer information between the body control module (BCM) and engine control module (ECM).
  • This procedure may be used with or without existing learned transmitters being present. If existing transmitters are present, keep the transmitters away from the vicinity of the vehicle. Failure to keep learned transmitters away from the vehicle will result in the learn changing to the Adding Transmitters procedure.
  1. Insert the mechanical key of the new transmitter into the key lock cylinder located on the outside of the driver door and turn the key to the unlock position five times within ten seconds. The Driver Information Center (DIC) will display Remote Learn Pending, Please Wait.
  2. After ten minutes, the DIC will display Press Engine Start Button To Learn. Press the ignition mode switch. The DIC will again display Remote Learn Pending, Please Wait.
  3. Repeat Step 2 two additional times, for a total of thirty minutes. All previously known transmitters have now been unlearned. Remaining transmitters can be relearned during the next steps. The DIC display will now display Ready For Remote # 1.
    4. NOTE:

    The transmitter pocket is the rear cup holder in the center console. Remove the rubber cupholder liner before placing the transmitter in the pocket. The transmitter must be placed tapered end facing forward with the buttons faced down in the cup holder. If a large key ring prevents the transmitter from being properly placed, remove the key ring and place the transmitter in the cup holder. Failure to position the transmitter properly will result in an inability to program.

  4. Place the new transmitter into the transmitter pocket.
  5. Press and release the ignition mode switch. After approximately 15 seconds the transmitter is learned and the next transmitter can be learned.
  6. Remove the transmitter from the transmitter pocket and press the unlock button. To program additional transmitters, repeat Steps 4 through 6.
  7. When all additional transmitters are programmed, press and hold the ignition mode switch for 5 seconds to exit programming mode.
scientia non olet · About LEMON Manuals