Installation Procedure
- Install Brake Pressure Modulator Valve Assembly (1)
- Install and tighten Brake Pressure Modulator Valve Bracket Nuts (1) (Qty: 3) to 7 N.m (62 lb in)
- Install and tighten Brake Pressure Modulator Valve Primary Pipe Fitting (1) to 32 N.m (24 lb ft)
- Install and tighten Brake Pressure Modulator Valve Secondary Pipe Fitting (1) to 32 N.m (24 lb ft)
- Install and tighten Left Rear Brake Pipe Fitting (1) to 18 N.m (13 lb ft)
- Install and tighten Right Front Brake Pipe Fitting (1) to 18 N.m (13 lb ft)
- Install and tighten Left Front Brake Pipe Fitting (1) to 18 N.m (13 lb ft)
- Install and tighten Right Rear Brake Pipe Fitting (1) to 18 N.m (13 lb ft)
- Connect the EBCM electrical connector.
- Bleed the brake system. Refer to Antilock Brake System Automated Bleed
- Install Plenum Front Panel. Refer to Plenum Front Panel Replacement
- Program the EBCM. Refer to Control Module References
CAUTION:
Refer to Fastener Caution