Circuit/System Verification
NOTE:
If the condition is intermittent or cannot be duplicated, disconnect the connectors and add Nyogel lubricant 760G. This procedure will correct the high resistance condition due to terminal fretting corrosion.
- Verify there is no debris on the B87 Rearview Camera lens and that the bezel and bezel seal are not damaged.
- If debris are found on the lens
Clean the lens. If the lens, bezel, or bezel seal are damaged, replace as necessary.
- Go to next step: If no debris on the lens
- If debris are found on the lens
- Ignition ON, transmission in R.
- Verify the backup lamps are illuminated.
- If the backup lamps are not illuminated
Refer to Backup Lamps Malfunction .
- Go to next step: If the backup lamps are illuminated
- If the backup lamps are not illuminated
- Verify the radio transitions to a rear vision image screen.
- If the radio does not transition to rear vision screen
Refer to Circuit/System Testing - Radio Malfunction.
- Go to next step: If the radio transitions to a rear vision screen
- If the radio does not transition to rear vision screen
- Verify a clear rear vision image is displayed on the radio.
- If a clear image is not displayed
Refer to Circuit/System Testing - Camera Malfunction.
- Go to next step: If a clear image is displayed
- If a clear image is not displayed
- All OK.