Removal Procedure

NOTE:

Before cutting out a stationary window, apply a double layer of masking tape around the perimeter of the painted surfaces and the interior trim.

Open the hood.
Windshield Garnish Molding Replacement - Remove
Windshield Wiper Arm Replacement - Remove
Inside Rearview Mirror Replacement - Remove
Lower the front section of the headlinder only to access the urethane adhesive bead. Headlining Trim Panel Replacement
WARNING:
If broken glass falls into the defroster outlets, it can be blown into the passenger compartment and cause personal injury.
Cover to protect the following parts from broken glass:
- Upper dash pad
- Defroster outlets and A/C outlets
- Seats and carpeting
Using the appropriate tool, carefully cut the lace from around the window in order to access the urethane adhesive bead.
WARNING:
Refer to Glass and Sheet Metal Handling Warning .
Do the following steps when separated the window from the urethane adhesive:
- Leave a base of urethane adhesive on the pinchweld flange.
- The only suitable lubrication is clean water, no oils, lubes or soaps.
- Use an appropriate stationary glass removal tool in order to remove the window.
Courtesy of GENERAL MOTORS COMPANY
Using the appropriate tool, cut along the bottom of the window separating the window from urethane adhesive. Keep the cutting edge of the tool against the window. Do this from inside the vehicle. While cutting from inside the vehicle, reposition the tool to cut the urethane adhesive along the top and both sides to release the window completely.

Courtesy of GENERAL MOTORS COMPANY
Remove the windshield (1) from the vehicle with an assistant, place the window on a clean soft surface.