LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2017 >> Cruze LS, Standard Trans >> Repair and Diagnosis >> Engine Mechanical >> Starter >> Battery, Charging System And Starting System >> Repair Instructions >> Battery Sensor Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: Battery Sensor
    GM3682629Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Do not tighten the battery sensor pole nut (2).

  1. Loosely install the battery sensor (1) carefully.
    2. Fig 2: Battery Negative Cable And Nut
    GM3682611Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Use a counterholder to prevent damage at the battery sensor.

  2. Install Battery Negative Cable (3)
  3. Install a open-end spanner (1) counterhold up the battery sensor as shown in the graphic.
    4. CAUTION:

    Refer to Fastener Caution .

  4. Install and tighten the battery negative cable nut (2) to 11 N.m (97 lb in).
    5. Fig 3: Wiring Harness Plug And Battery Negative Pole Nut
    GM3682628Courtesy of GENERAL MOTORS COMPANY
  5. Connect the wiring harness plug (1) to the battery sensor.
  6. Tighten the battery negative pole nut (2) to 4.5 N.m (40 lb in).
  7. Fold the rear seat back cushion in original position.
  8. Close the right rear door.
  9. Install Rear Compartment Floor Panel Trim Support
  10. Install Rear Compartment Floor Panel Trim
  11. Close the rear compartment lid.
  12. Ignition - On / Vehicle - In Service Mode & Engine - Off
  13. Program the volatile memory. Volatile Memory Programming .
  14. Program all of the customer's radio station presets and set the radio clock to the current time.
scientia non olet · About LEMON Manuals