Fastener Specifications
Single Use Non-Threaded Fasteners/Components
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|---|
| Application |
| Coolant Air Bleed Pipe Seal |
| Engine Coolant Thermostat Housing O-ring Seal |
| Water Pump Gasket |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Coolant Air Bleed Pipe at Cylinder Head Bolt | 12 N.m (106 lb in) |
| Coolant Recovery Reservoir Retaining Bolt | 17 N.m (13 lb ft) |
| Drain Cock Plug | 1.5 N.m (13 lb in) |
| Engine Coolant Fan Motor Bolt | 4 N.m (35 lb in) |
| Engine Coolant Fan Shroud Bolt | 5 N.m (44 lb in) |
| Engine Oil Cooler Inlet Hose Fitting Fastener | 75 N.m (55 lb ft) |
| Engine Oil Cooler Outlet Pipe Fastener | 9 N.m (80 lb in) |
| Fan Blade Nut | 6 N.m (53 lb in) |
| Fan Control Module Bolt | 5 N.m (44 lb in) |
| Radiator Upper Mount Bolt | 9 N.m (80 lb in) |
| Thermostat Housing at Water Pump Retaining Bolt | 14 N.m (124 lb in) |
| Water Pump Retaining Bolts | |
|
15 N.m (11 lb ft) |
|
30 N.m (22 lb ft) |