Fastener Specifications
WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
Single Use Threaded Fastener/Component Tightening Specifications
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Control Arm to Steering Knuckle Bolt and Nut | |
|
115 N.m (85 lb ft) |
|
120-135 degrees |
| Front Stabilizer Shaft Insulator Clamp Bolt | |
|
22 N.m (16 lb ft) |
|
30-45 degrees |
| Front Wheel Hub to Steering Knuckle Bolt | |
|
90 N.m (66 lb ft) |
|
60-75 degrees |
| Lower Control Arm to Subframe Bolt and Nut - Front | |
|
70 N.m (52 lb ft) |
|
75-90 degrees |
| Lower Control Arm to Subframe Bolt and Nut - Rear | |
|
70 N.m (52 lb ft) |
|
75-90 degrees |
| Rear Control Arm Bushing to Control Arm Bolt | |
|
55 N.m (41 lb ft) |
|
45-60 degrees |
| Stabilizer Shaft Link Nut | 65 N.m (48 lb ft) |
| Steering Knuckle Lower Camber Adjust Bolt and Nut | |
|
115 N.m (85 lb ft) |
|
45-60 degrees |
| Steering Knuckle Upper Camber Adjust Bolt and Nut | |
|
70 N.m (52 lb ft) |
|
45-60 degrees |
| Steering Knuckle to Upper Ball Stud Nut | |
|
45 N.m (33 lb ft) |
|
30 degrees |
|
15 degrees |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Front Shock Absorber Yoke Bolt and Nut | 70 N.m (52 lb ft) |
| Front Suspension Strut Mount Nut | 45 N.m (33 lb ft) |
| Steering Gear Outer Tie Rod to Steering Knuckle Nut | 35 N.m (26 lb ft) |
| Steering Knuckle King Pin Bolt | 7 N.m (62 lb in) |
| Steering Knuckle King Pin Bushing Nut | 70 N.m (52 lb ft) |