LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2017 >> Traverse LS Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 3.6L (LLT) - DTC P0010 To DTC P0336 >> Diagnostic Information and Procedures >> DTC P00F4-P00F6: Intake Air Humidity Sensor Circuit >> Circuit/System Verification
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Verification

NOTE:

To minimize the effects of residual engine heat and sensor internal heating elements, perform Steps 1 and 2 of this verification procedure only if the ignition has been OFF for 8 hours or more.

  1. Ignition ON.
  2. Verify the following scan tool parameters are within 10°C (18°F) of each other.
    • Start-Up IAT Sensor 1
    • Start-Up IAT Sensor 2
    • Start-Up ECT
    • If not within 10°C (18°F) 

      Refer to Circuit/System Testing.

    • If within 10°C (18°F) 
  3. Engine idling, verify the scan tool Intake Air Humidity parameter is between 5 and 90 %.
    • If not between 5 and 90 % 

      Refer to Circuit/System Testing.

    • If between 5 and 90 % 
  4. Operate the vehicle within the conditions for running the DTC. You may also operate the vehicle within the conditions that you observed from the freeze frame/failure records data.
  5. Verify the DTC does not set.
    • If the DTC sets 

      Refer to Circuit/System Testing.

    • If the DTC does not set 
  6. All OK.
scientia non olet · About LEMON Manuals