Component Testing
Memory Switch
- Disconnect the harness connector at the memory seat adjuster switch.
- Test for infinite resistance between the signal terminal 1 and the 12 V reference terminal 2.
- If not the specified value, replace the memory seat adjuster switch.
- Test the resistance between terminal 1 and terminal 2 while pressing the memory 1, memory 2, and EXIT buttons. Compare the resistance readings to the values in the Memory Switch Values table below.
- If the resistance is not within the specified range, replace the memory seat adjuster switch.
Memory Switch Values
| Switch Position | Resistance |
|---|---|
| Idle | Infinite |
| Memory 1 | 2.03K - 2.49K Ω |
| Memory 2 | 3.83K - 4.69K Ω |
| EXIT | 8.33K - 10.18K Ω |