LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2017 >> Traverse Premier, AWD >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Diagnostic Information and Procedures >> DTC P0622: Generator F-Terminal Circuit >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

  1. Verify a test lamp illuminates between the G13 Generator B+ circuit terminal A X1, A X2, B X2, 1 X1 or 1 X2 and ground.
    • If the test lamp does not illuminate and the circuit fuse is good 
    1. Remove the test lamp and disconnect the B+ cable at the G13 Generator.
    2. Test for less than 2 Ω in the B+ circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit.
      • If less than 2 Ω, verify the fuse is not open and there is voltage at the fuse.
    • If the test lamp does not illuminate and the circuit fuse is open 
    1. Remove the test lamp, disconnect the battery negative cable, and disconnect the G13 Generator B+ cable.
    2. Test for infinite resistance between the B+ circuit and ground.
      • If less than infinite resistance, repair the short to ground on the circuit.
      • If infinite resistance, test or replace the G13 Generator.
    • If the test lamp illuminates 
  2. Ignition Off, Disconnect the X1 harness connector at the G13 Generator, engine running.
  3. Verify the scan tool Engine Control Module Generator F-Terminal Signal parameter is less than 5%.
    • If 5% or greater 
    1. Ignition OFF, disconnect the appropriate harness connector at the K20 Engine Control Module, ignition ON.
    2. Test for less than 1 V between the signal circuit terminal 2 and ground.
      • If 1 V or greater, repair the short to voltage on the circuit.
      • If less than 1 V, replace the K20 Engine Control Module.
    • If less than 5% 
  4. Install a 3 A fused jumper wire between the signal circuit terminal 2 and B+, engine running.
  5. Verify the scan tool Engine Control Module Generator F-Terminal Signal parameter is greater than 95%.
    • If 95% or less 
    1. Ignition OFF, remove the jumper wire, disconnect the appropriate harness connector at the K20 Engine Control Module.
    2. Test for infinite resistance between the signal circuit and ground.
      • If less than infinite resistance, repair the short to ground on the circuit.
      • If infinite resistance
    3. Test for less than 2 Ω in the signal circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit
      • If less than 2 Ω, replace the K20 Engine Control Module.
    • If greater than 95% 
  6. Test or replace the G13 Generator.
scientia non olet · About LEMON Manuals