LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2018 >> Bolt EV Premier >> Repair and Diagnosis >> Hybrid/Electric Powertrain >> Electric Converters and Controllers >> Hybrid/EV Control System >> Repair Instructions >> Drive Motor Power Inverter Module Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

  1. GM4529672Courtesy of GENERAL MOTORS COMPANY

    Drive Motor Power Inverter Module (1) - Install

  2. GM4529671Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

    Drive Motor Power Inverter Module Bolt (1) - Install [2x] 22N.m (16 lb ft)

  3. Drive Motor Power Inverter Module Nut (2) - Install 22N.m (16 lb ft)
  4. GM4529670Courtesy of GENERAL MOTORS COMPANY

    Drive Motor Generator Control Module Cooling Outlet Hose (3) - Install the Hose and Engage the Clamp (1)

  5. Drive Motor Generator Control Module Radiator Outlet Hose (2) - Install the Hose and Engage the Clamp (1)
  6. GM4581955Courtesy of GENERAL MOTORS COMPANY

    Clean all of the gasket surfaces.

  7. Drive Motor Power Inverter Module 3-Phase Cable Seal (6) - Install NEW
  8. Drive Motor Power Inverter Module 3-Phase Cable (5) - Install
    9. CAUTION:

    Refer to Fastener Caution .

  9. Drive Motor Power Inverter Module 3-Phase Cable Bolt (4) - Tighten [3x] 9N.m (80 lb in)
  10. Drive Motor Power Inverter Module 3-Phase Cable Cover Seal (3) - Install NEW
  11. Drive Motor Power Inverter Module 3-Phase Cable Cover (2) - Install
  12. Drive Motor Power Inverter Module 3-Phase Cable Cover Nut (1) - Install [2x] 9N.m (80 lb in)
  13. GM4529668Courtesy of GENERAL MOTORS COMPANY

    Engine Wiring Harness Connector (2) - Install.

  14. Lock the handle (1) into lock position.
  15. GM4529667Courtesy of GENERAL MOTORS COMPANY

    Drive Motor Power Inverter Module Shield (3) - Install

  16. Ground Cable (4) - Install
  17. Drive Motor Power Inverter Module Shield Bolt (1) - Install 9N.m (80 lb in)
  18. Drive Motor Power Inverter Module Shield Bolt (2) - Install 25N.m (18 lb ft)
  19. GM4529666Courtesy of GENERAL MOTORS COMPANY

    Engine Wiring Harness Bracket (2) @ Accessory DC Power Control Module (3) - Install

  20. Engine Wiring Harness Bracket Bolt (1)@ Accessory DC Power Control Module (3) - Install 22N.m (16 lb ft)
  21. High Voltage Battery Control Wiring Junction Block - Install - High Voltage Battery Control Wiring Junction Block Replacement (With quick charge) High Voltage Battery Control Wiring Junction Block Replacement (Without quick charge) 
  22. Radiator Surge Tank Support Bracket (RESS) - Install - Radiator Surge Tank Support Bracket Replacement (Radiator)Radiator Surge Tank Support Bracket Replacement (Heater)Radiator Surge Tank Support Bracket Replacement (RESS)
  23. Fill the drive motor generator power inverter module cooling system. Drive Motor Generator Power Inverter Module Cooling System Draining and Filling
  24. Enable the high voltage system. High Voltage Enabling
  25. Program the Drive Motor Power Inverter Module. Control Module References
scientia non olet · About LEMON Manuals