Removal Procedure
WARNING:
WARNING:
- Fuel Tank Replacement - Remove
- Fuel Feed Pipe Replacement - Fuel Pump Module to Underbody - Remove
Electrical Connector(1) - Disconnect[2x]
- Disconnect the evaporative emission canister vent pipe (2). Refer to Plastic Collar Quick Connect Fitting Service .
Install the CH-45722 Main Fuel Pump Locking Ring Remover/Installer (1) to the fuel pump module lock ring (2).
- Using the CH-45722 Main Fuel Pump Locking Ring Remover/Installer (1) and a long breaker-bar, rotate the lock ring in a counterclockwise direction in order to unlock the lock ring.
- Remove the CH-45722 Main Fuel Pump Locking Ring Remover/Installer (1).
- NOTE:
Lift the fuel tank fuel pump module up slightly. Pay attention to the fuel level sensor.
Remove the fuel tank pump module locking ring (1).
- Fuel Tank Fuel Pump Module(2) - Remove
- Remove and DISCARD the fuel pump module seal (3).
- Fuel Level Sensor Replacement - Remove
- Fuel Tank Pressure Sensor Replacement - Remove
NOTE:
DO NOT use impact tools. Significant force will be required to release the lock ring. The use of a hammer and screwdriver is not recommended. Secure the fuel tank in order to prevent fuel tank rotation.