LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2018 >> Cruze LS, Standard Trans >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 1.4L (LE2) - Repair Instructions >> Repair Instructions >> Fuel Injection Fuel Rail Fuel Pressure Sensor Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

  1. GM4090993
    NOTE:

    Applying force to the plastic housing of the sensor may damage the sensor. To tighten or loosen, apply force only to the attached hexagon.

    NOTE:

    Ensure that the fuel rail threads have been cleaned of any excess fuel, or the NEW fuel injection fuel rail fuel pressure sensor will NOT seal properly.

    Lubricate the threads and sealing surface of the NEW fuel rail pressure sensor with one drop of clean engine oil.

  2. Install the NEW fuel rail pressure sensor (2) to fuel injection fuel rail (3) and hand tighten.
  3. Fuel Injection Fuel Rail Fuel Pressure Sensor(1) - Remove@Fuel Injection Fuel Rail Assembly(3)
  4. Re-lubricate with one drop of clean engine oil.
    5. CAUTION:

    Refer to Fastener Caution .

  5. Fuel Injection Fuel Rail Fuel Pressure Sensor(1) - Install and tighten 32 N.m (24 lb ft).
  6. Connect the electrical connector (2).
  7. Inspect for fuel leaks using the following procedure:
    1. Turn the ignition ON, with the engine OFF for 2 seconds
    2. Turn OFF the ignition. for 10 seconds.
    3. Ignition On, engine Off.
    4. Inspect for fuel leaks, using tissue paper or hydrocarbon sniffer.
    5. Start vehicle and re-inspect for fuel leaks with engine at idle.
    6. Re-inspect for fuel leaks with engine at 3, 000 rpm no load.
  8. Engine Sight Shield Replacement - Install
  9. Battery Negative Cable Disconnection and Connection - Connect
scientia non olet · About LEMON Manuals