Installation Procedure
- Clean and inspect the fuel injector prior to reinstalling it. Fuel Injector Cleaning and Inspection
Combustion Fuel Injector Seal (1) - Install NEW
Slide the fuel injector hold down clamp (2) into the grooves on the fuel injector (1) and install them together into the valve rocker arm cover ensuring that the fuel injector locating pin engages the fuel injector hold down clamp.
Fuel Injector Washer (2) - Install
- Fuel Injector Bracket Bolt (1) - Install and tighten to 30 N.m (22 lb ft)
Electrical Connector (1) @ Fuel Injector (2) - Connect
- Replace the fuel filter. Fuel Filter Replacement
- Prime the fuel system. Fuel System Priming
- With the engine running, check the fuel system for leaks.
- Fuel Injector Deadener - Install - Fuel Injector Deadener Replacement
- Perform the fuel injection small quantity learn. Fuel Injection Small Quantity Learn
- Perform the fuel trim reset. Fuel Trim Reset
- Perform the high pressure fuel correction reset. High Pressure Fuel Correction Reset
- Perform the fuel injector flow rate programming. Fuel Injector Flow Rate Programming
CAUTION:
Refer to Fastener Caution .
NOTE:
If applicable, perform the fuel filter life reset after replacing the fuel filter.