Fastener Specifications
WARNING: This page is about a different car, the 2019 Buick Cascada, 2018 Buick Cascada, and 2017 Buick Cascada. However, it is still accessible from the selected car via links, so may be relevant.
Single Use Non-Threaded Fasteners/Components
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|---|
| Application |
| Engine Coolant Thermostat Housing Gasket |
| Engine Oil Cooler Seal |
| Oil Cooler Housing Seal |
| Turbocharger Coolant Feed Pipe Clamp |
| Turbocharger Coolant Feed Pipe Fitting Seal |
| Turbocharger Coolant Feed Pipe Seal Ring |
| Turbocharger Coolant Return Pipe Clamp |
| Turbocharger Coolant Return Pipe Fitting Seal |
| Water Outlet Seal |
| Water Pump Inlet Pipe Seal |
| Water Pump Seal |
Single Use Threaded Fastener/Component Tightening Specifications
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Turbocharger Coolant Feed Pipe Fitting | 24 N.m (18 lb ft) |
| Turbocharger Coolant Return Pipe Fitting | 24 N.m (18 lb ft) |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Auxiliary Water Pump Bracket Bolt | 10 N.m (89 lb in) |
| Engine Coolant Fan Motor Bolt | 4 N.m (35 lb in) |
| Engine Coolant Fan Resistor Bolt | 4 N.m (35 lb in) |
| Engine Coolant Thermostat Housing Bolt | 9 N.m (80 lb in) |
| Engine Oil Cooler Assembly Bolt | 25 N.m (18 lb ft) |
| Engine Oil Cooler Bolt | 9 N.m (80 lb in) |
| Hood Hold Open Rod Retainer Bracket Bolt | 22 N.m (16 lb ft) |
| Radiator Bracket Bolt | 25 N.m (18 lb ft) |
| Radiator Drain Cock | 2 N.m (18 lb in) |
| Radiator Support Bracket Bolt | 22 N.m (16 lb ft) |
| Radiator Vent Valve | 2 N.m (18 lb in) |
| Turbocharger Coolant Feed Pipe Bracket Bolt | 10 N.m (89 lb in) |
| Turbocharger Coolant Feed Pipe to Turbocharger | 20 N.m (15 lb ft) |
| Turbocharger Coolant Return Pipe Bracket Fastener | 10 N.m (89 lb in) |
| Water Outlet Housing Bolt | 7 N.m (62 lb in) |
| Water Pump Housing Bolt | 9 N.m (80 lb in) |
| Water Pump Inlet Pipe Bolt | 25 N.m (18 lb ft) |
| Water Pump Pulley Bolt | 9 N.m (80 lb in) |