Installation Procedure
- NOTE:
Only use a battery with the same part number and the same battery characteristics like nominal capacity and open circuit voltage.
Battery (1) - Install
- Battery Hold Down Retainer (4) - Install
- Install the battery hold down retainer nut (3) and tighten to 10 N.m (89 lb in).
- Install the battery vent tube (2) to the battery.
Connect the battery to fuse block cable (1).
- Tighten the battery positive cable nut (2) to 4.5 N.m (40 lb in).
Install the battery negative cable (1) along with the battery sensor (2) to the battery.
- Tighten the battery negative cable nut (2) to 4.5 N.m (40 lb in).
- Fold the rear seat back cushion in original position.
- Close the right rear door.
- Rear Compartment Floor Panel Trim Support - Install - Rear Compartment Floor Panel Trim Support Replacement
- Rear Compartment Floor Panel Trim Replacement (Notchback)Rear Compartment Floor Panel Trim Replacement (Hatchback) - Install
- Close the rear compartment lid.
- Insert the ignition key and turn the ignition to the ON position.
- Program the volatile memory. Volatile Memory Programming .
CAUTION: