Fastener Specifications

WARNING: This page is about a different car, the 2018 Chevrolet Cruze. However, it is still accessible from the selected car via links, so may be relevant.

Single Use Threaded Fastener/Component Tightening Specifications

NOTE: All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal.
Application	Specification
Application	Metric (English)
Front Lower Control Arm Bushing Bolt
First Pass:	100 N.m (74 lb ft)
Final Pass:	30 - 45 Degrees
Front Lower Control Arm Bushing Bolt and Nut
First Pass:	100 N.m (74 lb ft)
Final Pass:	90 - 105 Degrees
Front Shock Absorber Upper Nut
First Pass:	35 N.m (26 lb ft)
Final Pass:	30 - 45 Degrees
Front Stabilizer Shaft Bolt
First Pass:	22 N.m (16 lb ft)
Final Pass:	30 - 45 Degrees
Front Stabilizer Shaft Link Nut	65 N.m (48 lb ft)
Front Suspension Strut Mount Nut	45 N.m (33 lb ft)
Front Wheel Bearing And Hub Bolt
First Pass:	90 N.m (66 lb ft)
Final Pass:	60 - 75 Degrees
Lower Control Arm to Steering Knuckle Nut
First Pass:	35 N.m (26 lb ft)
Final Pass:	30 - 45 Degrees
Steering Gear Outer Tie Rod to Steering Knuckle Nut
First Pass:	35 N.m (26 lb ft)
Final Pass:	30 - 45 Degrees
Steering Knuckle to Strut Assembly Nut
First Pass:	100 N.m (74 lb ft)
Final Pass:	45 - 60 Degrees

Reusable Threaded Fastener Tightening Specifications

NOTE: All fasteners listed in this table can be reused after removal.
Application	Specification
Application	Metric (English)
Front Wheel Speed Sensor Bolt	6 N.m (53 lb in)