Installation Procedure
Install the wheel speed sensor (1) to the rear drum brake spacer.
- CAUTION:
Refer to Fastener Caution .
Install the wheel speed sensor bolt (1) and tighten to 8 N.m (71 lb in).
Connect the wheel speed sensor electrical connector (1) and install the connector to the wheelhouse bracket.
- Install the wheel speed sensor harness retainer (2) to the wheel cylinder brake pipe.
- Install the wheel speed sensor harness grommets (3) to the bracket.
Install the rear wheel speed sensor harness connector cover (1).
Install the rear wheel speed sensor harness connector cover nuts (1) and tighten to 2 N.m (18 lb in).
- Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
- Perform the Diagnostic System Check - Vehicle .
NOTE:
If the wheel speed sensor grommets are equipped with a molded rib, position the grommets with the rib at the open end of the wheel speed sensor harness brackets. Do not twist the wheel speed sensor harness.