Programming a New Control Module
WARNING: This page is about a different car, the 2018 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
To program a new control module, perform the following procedure:
- Open the Service Programming System (SPS) - Refer to: Service Programming System (SPS)
- Select: J2534 MDI
- Select: Replace and Program ECU
- Select: Vehicle Data
- Select: K71 Transmission Control Module
- Select: Programming
- Select: Normal
- Follow the on-screen instructions.
- Select: Configuration & Setup
- Select: Normal
- Follow the on-screen instructions.
NOTE:
The following procedure updates the control module software.
NOTE:
The following procedure configures the control module and carries out all necessary further steps for proper functioning of the control module.