Installation Procedure
Battery (1) - Install
Battery Hold Down Retainer (3) - Install
- Battery Hold Down Retainer (1) - Install
- Battery Hold Down Retainer Bolt (2) - Install and tighten 22 N.m (16 lb ft)
Battery Distribution Engine Compartment Fuse Block (3) - Install
- Battery Positive Post Clamp Nut (1) - Tighten 4.5 N.m (40 lb in)
- Battery Distribution Engine Compartment Fuse Block Cover (2) - Install
- Connect the battery negative cable. Battery Negative Cable Disconnection and Connection (without KL9) Battery Negative Cable Disconnection and Connection (with KL9)
CAUTION:
Refer to Fastener Caution .