Replace and Program Control Module or Reprogram Control Module
WARNING: This page is about a different car, the 2019 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
To program a replacement or an existing control module, perform the following procedure:
- Using the steering wheel, align and center the front wheels forward.
- Apply the parking brake, and set the transmission in Park if equipped with an automatic transmission.
- Turn ON the ignition, with the engine OFF.
- Access the Service Programming System (SPS) and follow the on-screen instructions. Refer to Service Programming System (SPS)
- On the SPS Supported Controllers screen, select Power Steering Control Module - Programming and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select Power Steering Control Module - Configuration & Setup and follow the on-screen instructions.
- Perform the Steering Angle Sensor Centering. Refer to Power Steering Control Module Calibration
- Clear all DTCs after completing the programming and setup procedures.
- Turn OFF the ignition.