LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2020 >> Trax LS, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 1.8L (2H0) >> Repair Instructions >> Fuel Tank Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

  1. Transfer the fuel tank fuel pump module. Refer to Fuel Tank Fuel Pump Module Replacement (FWD) .
  2. Transfer the evaporative emission canister. Refer to Evaporative Emission Canister Replacement (FWD) .
  3. Install the fuel tank to the hydraulic lift.
  4. GM2781362Courtesy of GENERAL MOTORS COMPANY

    With the aid of an assistant, position the fuel tank to the vehicle.

    5. CAUTION:

    Refer to Fastener Caution .

  5. Install both fuel tank straps to the fuel tank (2) and tighten the fasteners to 22 N.m (16 lb ft).
  6. Remove the hydraulic lift from the fuel tank.
  7. Connect the EVAP system hoses. Refer to Evaporative Emission System Hose/Pipe Replacement (2H0) , Evaporative Emission System Hose/Pipe Replacement (Fuel Pump Module to Vent Pipe FWD) , Evaporative Emission System Hose/Pipe Replacement (Fuel Pump Module to Canister FWD) , and Evaporative Emission System Hose/Pipe Replacement (Canister to Pipe FWD) .
  8. Connect the fuel feed pipe. Refer to Fuel Feed Pipe Replacement (2H0) , and Fuel Feed Pipe Replacement (At Tank FWD) .
  9. Connect the fuel tank filler pipe. Refer to Fuel Tank Filler Pipe Replacement .
  10. GM2781400Courtesy of GENERAL MOTORS COMPANY

    Connect the fuel tank fuel pump module wiring harness (1) and clip the fuel tank module wiring harness to the chassis.

  11. Install the exhaust. Refer to Exhaust Muffler Replacement (2H0) .
  12. Install the right rear wheelhouse panel liner. Refer to Rear Wheelhouse Liner Replacement .
  13. Lower the vehicle.
scientia non olet · About LEMON Manuals