Installation Procedure
WARNING: This page is about a different car, the 2020 Chevrolet Bolt EV. However, it is still accessible from the selected car via links, so may be relevant.
Using a flat bladed tool, release the ECM bracket retainer. Slide the ECM and bracket assembly to the battery tray.
- Engine Control Module (2) - Install
- Engine Control Module Bracket Nut (1) - Install and tighten [4x] 4.7 N.m (42 lb in)
Engine Control Module Electrical Connector (1) - Connect
- Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection
- If replacing the engine control module, reprogram the module. Control Module References
CAUTION: