Removal Procedure
WARNING:
CAUTION:
Always connect or disconnect the wiring harness connector from the EBCM/EBTCM with the ignition switch in the OFF position. Failure to observe this precaution could result in damage to the EBCM/EBTCM.
- Place the ignition switch in the OFF position.
- Plenum Front Panel - Remove - Plenum Front Panel Replacement (LTG LGX) , or Plenum Front Panel Replacement (LT1 LT4)
- Thoroughly clean the electronic brake control module (EBCM) to brake pressure modulator valve (BPMV) area of any accumulated dirt and debris.
- Disconnect the EBCM electrical connector.
Right Rear Brake Pipe Fitting (1) - Disconnect
- Cap the brake pipe fitting and plug the BPMV outlet port to prevent brake fluid loss and contamination.
Left Front Brake Pipe Fitting (1) - Disconnect
- Cap the brake pipe fitting and plug the BPMV outlet port to prevent brake fluid loss and contamination.
Right Front Brake Pipe Fitting (1) - Disconnect
- Cap the brake pipe fitting and plug the BPMV outlet port to prevent brake fluid loss and contamination.
Left Rear Brake Pipe Fitting (1) - Disconnect
- Cap the brake pipe fitting and plug the BPMV outlet port to prevent brake fluid loss and contamination.
Brake Pressure Modulator Valve Secondary Pipe Fitting (1) - Disconnect
- Cap the brake pipe fitting and plug the BPMV inlet port to prevent brake fluid loss and contamination.
Brake Pressure Modulator Valve Primary Pipe Fitting (1) - Disconnect
- Cap the brake pipe fitting and plug the BPMV inlet port to prevent brake fluid loss and contamination.
Brake Pressure Modulator Valve Bracket Nut (1) - Remove [3x]
Brake Pressure Modulator Valve Assembly (1) - Remove