Fastener Specifications
Single Use Non-Threaded Fasteners/Components
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|---|
| Application |
| Catalytic Converter Gasket |
| Exhaust Manifold Gasket |
Single Use Threaded Fastener/Component Tightening Specifications
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Exhaust Manifold Bolt | |
| First Pass: | 27 N.m (20 lb ft) |
| Second Pass: | loosen 180 degrees |
| Final Pass: | 23 N.m (17 lb ft) |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Catalytic Converter Brace Bolt | 22 N.m (16 lb ft) |
| Catalytic Converter Heat Shield Bolt | 10 N.m (89 lb in) |
| Catalytic Converter Nut | 58 N.m (43 lb ft) |
| Exhaust Control Valve Actuator Bolt | 10 N.m (89 lb in) |
| Exhaust Hanger Bracket Bolt | 22 N.m (16 lb ft) |
| Exhaust Heat Shield Bolt | 8 N.m (71 lb in) |
| Exhaust Heat Shield Bolt With GPF |
10 N.m (89 lb in) |
| Exhaust Manifold Heat Shield Bolt | 10 N.m (89 lb in) |
| Exhaust System Rear Nut | 22 N.m (16 lb ft) |
| Exhaust System Washer | 1.5 N.m (13 lb in) |
| Exhaust Muffler Hanger Bracket Bolt | 22 N.m (16 lb ft) |