Removal Procedure
Refer to SIR Warning .
Use care when working around the head curtain inflator module. Sharp tools may puncture the curtain airbag. If the head curtain inflator module is damaged in any way, it must be replaced.
3rd Row Seat (2) - Remove - 3rd Row Seat Removal and Installation
- Disable the SIR system. SIR Disabling and Enabling
Using a flat-bladed plastic trim tool, release the retaining clips.
- Rear Side Door Sill Garnish Molding (1) - Remove
Place the rear seat (1) in the fold and tumble position.
Liftgate Weatherstrip (1) - Reposition
Liftgate Lock Striker Cover (1) - Remove
Using a flat-bladed plastic trim tool, release the retaining clips.
- Rear End Trim Finish Panel (1) - Remove
Rear Seat Belt Retractor Sleeve (1) - Reposition
- Rear Seat Belt Anchor Plate Bolt (2) - Remove
Rear Seat Belt Opening Bezel (1) - Disengage
Quarter Window Trim Finish Panel Bolt Cap (1) - Remove
- Quarter Window Trim Finish Panel Bolt (2) - Remove
Using a flat-bladed plastic trim tool, release the retaining clips.
- Body Lock Pillar Upper Trim Panel (1) - Remove
Using a flat-bladed plastic trim tool, release the retaining clips.
- Pull the body side rear window garnish molding (1) outwards enough to access the tether fastener.
Body Side Rear Window Garnish Molding Bolt (1) - Remove
- Body Side Rear Window Garnish Molding Tether Retaining Clip (2) - Remove
Body Rear Corner Upper Garnish Molding Bolt (1) - Remove
Using a flat-bladed plastic trim tool, release the retaining clips.
- Body Rear Corner Upper Garnish Molding (1) - Remove
Electrical Connector (1) - Disconnect
- Wiring Harness Retainer (2) - Remove
3rd Row Seat Belt Retractor Bolt- Lower (1) - Remove
Using a flat-bladed plastic trim tool, release the retaining clips.
- Rear Seat Belt Opening Bezel (1) - Remove
3rd Row Seat Belt Retractor Anchor Cover (1) - Open
- 3rd Row Seat Belt Retractor Bolt- Upper (2) - Remove
Convenience Net Retainer (1) - Remove
- Cargo Tie Down Loop Bolt Cap (2) - Open
- Cargo Tie Down Loop Bolt (3) - Remove
- Cargo Tie Down Loop (4) - Remove
Using a flat-bladed plastic trim tool, release the retaining clips.
- Quarter Lower Rear Trim Panel (1) - Remove
Disconnect the electrical connectors (1).
- Remove the wiring harness retainers (2).
Disconnect all electrical connectors.
- Radio Speaker Amplifier Bolt (1) - Remove [3x]
- Radio Speaker Amplifier (2) - Remove
Radio Speaker Amplifier Bracket Nut (1) - Remove [4x]
- Reposition the wiring harness.
- Radio Speaker Amplifier Bracket (2) - Remove
Disconnect the electrical connectors.
- Video Processing Module Nut (1) - Remove [2x]
- Video Processing Module (2) - Remove
Feed the rear seat belt opening bezel and rear seat belt through the body lock upper trim panel.
Feed the rear seat belt opening bezel and 3rd row seat belt through the quarter lower rear trim panel.