Installation Procedure

Front Wheel Speed Sensor Wiring Harness (1) - Install

Courtesy of GENERAL MOTORS COMPANY
Connect the electrical connector. (2)
Front Wheel Speed Sensor Retainer (3) - Install
Front Wheel Speed Sensor Bracket (3) - Install

Courtesy of GENERAL MOTORS COMPANY
Front Wheel Speed Sensor Retainer (2) - Install

CAUTION:

Front Wheel Speed Sensor Bracket Bolt (1) - Install and tighten - Fastener Specifications
{If equipped }Wiring Harness (1) @Front Wheel Speed Sensor Bracket - Install [3x]

Courtesy of GENERAL MOTORS COMPANY

NOTE:
Typical front wheel speed sensor bracket shown, actual image may vary based on option content.
Front Wheel Speed Sensor Wiring Harness (1) @Wiring Harness Bracket - Install

Courtesy of GENERAL MOTORS COMPANY
Front Wheel Speed Sensor Bracket (2) - Install

Courtesy of GENERAL MOTORS COMPANY
Front Wheel Speed Sensor Bracket Bolt (1) - Install and tighten - Fastener Specifications
Apply a light coat of wheel speed anti-corrosion grease to the front wheel speed sensor (3) and mounting pad on the front steering knuckle. Adhesives, Fluids, Lubricants, and Sealers
Front Wheel Speed Sensor (3) - Install
Front Wheel Speed Sensor Bolt (4) - Install and tighten - Fastener Specifications
Install the front tire and wheel assembly. Tire and Wheel Removal and Installation (Steel Wheel) , or Tire and Wheel Removal and Installation (Aluminum Wheel)
Remove the support and lower the vehicle.
Verify the repair is complete. Diagnostic Repair Verification