Circuit/System Testing
WARNING: This page is about a different car, the 2020 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the harness connector at the S48E Multifunction Switch Center Console.
- Verify a test lamp illuminates between terminal 6 and B+.
- If the test lamp does not illuminate
Repair the open or high resistance on circuit 1450 or the ground point for circuit 1450.
- Go to next step: If the test lamp illuminates
- If the test lamp does not illuminate
- Connect the harness connector at the S48E Multifunction Switch Center Console.
- Disconnect the X2 harness connector at the K9 Body Control Module.
- Test for infinite resistance between terminal 10 and ground.
- If less than infinite resistance
- Test circuit 2202 for a short to ground.
- If a short to ground is found, repair the fault on circuit 2202.
- Go to next step: If a short to ground is not found
- Replace the S48E Multifunction Switch Center Console.
- Go to next step: If infinite resistance
- Test for less than infinite resistance between terminal 10 and ground while pressing and holding the S48E Multifunction Switch Center Console.
- Go to next step: If infinite resistance
- Test circuit 2202 for an open/high resistance.
- If an open/high resistance is found, repair the fault on circuit 2202.
- Go to next step: If an open/high resistance is not found
- Replace the S48E Multifunction Switch Center Console.
- If less than infinite resistance
- Replace the K9 Body Control Module.