Installation Procedure
WARNING: This page is about a different car, the 2021 Chevrolet Tahoe and 2021 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.
- Active Safety Control Module (1) - Install
- Secure the retaining tab.
- Install wiring harness retainers
- Active Safety Control Module Bracket (2) - Install
- Active Safety Control Module Bracket Nut (1) - Install and tighten [2x] - Fastener Specifications
- Connect the electrical connectors.
- Install the wiring harness retainers, as needed.
- Quarter Lower Rear Trim Panel (1) - Install
- Cargo Tie Down Loop (4) - Install
- Cargo Tie Down Loop Bolt (3) - Install and tighten - Fastener Specifications
- Cargo Tie Down Loop Bolt Cap (2) - Close
- Convenience Net Retainer (1) - Install and tighten - Fastener Specifications
- 3rd Row Seat Belt Retractor Bolt- Lower (1) - Install and tighten - Fastener Specifications
- Body Rear Corner Upper Garnish Molding (1) - Install
- Body Rear Corner Upper Garnish Molding Bolt (1) - Install and tighten - Fastener Specifications
- Body Side Rear Window Garnish Molding (1) - Install
- Body Lock Pillar Upper Trim Panel (1) - Install
- Quarter Window Trim Finish Panel Bolt (2) - Install and tighten - Fastener Specifications
- Quarter Window Trim Finish Panel Bolt Cap (1) - Install
- Rear Seat Belt Retractor Anchor Plate Bolt (2) - Install and tighten - Fastener Specifications
- Rear Seat Belt Retractor Sleeve (1) - Reposition
- Rear End Trim Finish Panel (1) - Install
- Liftgate Lock Striker Cover (1) - Install
- Liftgate Weatherstrip (1) - Reposition
- Return the rear seat (1) to the original position.
- Rear Side Door Sill Garnish Molding (1) - Install
- Enable the SIR System. SIR Disabling and Enabling
- 3rd Row Seat (2) - Install - 3rd Row Seat Removal and Installation
CAUTION:
Refer to Fastener Caution .